XSR 700 Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
Hey all,
Please forgive me if this has been covered already but I can't seem to find any information on it.
I'm attempting to replace my headlight bucket after it cracked as a result of a truck reversing into me.
I've managed to take out the old bucket and removed all dust gromit and wires etc, but the issue is inserting the headlight connection through the stock hole. It's simply too small.
Any recommendations on how this is inserted and connected please?
Automotive tire Automotive lighting Automotive fuel system Motor vehicle Vehicle
Automotive tire Hood Motor vehicle Automotive lighting Bumper
 

·
Registered
Joined
·
580 Posts
Not sure or remember, either the ring in the bucket picture is an other gromit or rubber ring as well. You may remove it to get the right diameter.

Or it is just track back the headlight wire to the next plug connection.
 
1 - 4 of 4 Posts
Top