XSR 700 Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Hey guys, new XSR owner here. Loving the bike so far.

I've got some flush mount front indicators on the way and had a question about the headlight bracket bolts. On the Euro bikes the bracket is tight to the headlight, but here in the US it is bumped out with spacers. I'm going to take the spacers out. I can figure out the length pretty easily - old bolt length minus spacer length, but I was wondering if anybody had the diameter / thread pitch handy.

If nobody knows I will figure it out at a hardware store and reply to this thread for the next guy.
 

·
Registered
Joined
·
36 Posts
I think you’ll need a couple sets of fasteners. When I took out my “super safe US spacers” I replaced them with: SS M6 hex screws (4 x 16mm, 2 x 25mm)


Jacob
Location: Cincinnati, OH
Bike: 2018 XSR700, brushed aluminum
Mods & Gear: cappuccinomoto.com/moto
 
1 - 4 of 4 Posts
Top