[petitdav]

hello, what tightening torque for the handlebar?
is there a table for the tightening torques?

 

[geoffb]

hello, what tightening torque for the handlebar?
is there a table for the tightening torques?

This has been covered before here:

Looking For Advice On An Issue After Handlebar Installation

Hey owners, I recently installed a new Pro Taper Handlebar on my 2018 XSR700. It looks great however I noticed there is a little gap on the left side between the clamps. See the pic below. I tighten the screws as hard as I could when installing but the gap was still there. When Installing...

www.xsr700forums.com

 

[Smooth Cornering]

If you search for "XSR700 Service Manual" you will find all the answers you need
Unfortunately the manual is too large to upload on this website.
I have attached a screen shot of page 4-65.

 

[petitdav]

Tank you