XSR 700 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
156 Posts
Discussion Starter · #1 ·
Hi there

Does anyone know where i can get another trim for the silver yam fly screen?

My original 'went missing' so i tried an aftermarket trim but it wouldn't bend around the corners!

Thanks for any help
 

·
Registered
Joined
·
294 Posts
Hi there

Does anyone know where i can get another trim for the silver yam fly screen?

My original 'went missing' so i tried an aftermarket trim but it wouldn't bend around the corners!
I had a fairly hard time locating some as I wanted something a little bit glossier than the original as the very Rubbery one Yamaha supplied seemed too agricultural for the Screen.
It also tended to look scruffy rather quickly, with the surface being a bit tacky, it attracted marks and dust.
I ended up buying 2 varieties from Louis.
(I purchased both in Black, but they are also available in Smoke, Clear and Chrome. Note I have not fitted the Trim yet but it appears flexible enough not to have any issues bending around the Screen's corners):

Rubber Edge Trim:
https://www.louis-moto.co.uk/artike...0006098?list=2be44dd80ecdab2cff5da14a2b7d61c2

Anodised Edge Trim:
https://www.louis-moto.co.uk/artike...0006086?list=2be44dd80ecdab2cff5da14a2b7d61c2


I would also advise buying the "Edge Trim Clamps" as they clean up the area where the Trim terminates:

https://www.louis-moto.co.uk/artike...0006137&list=2be44dd80ecdab2cff5da14a2b7d61c2
 

·
Registered
Joined
·
18 Posts
Just fitted the Yamaha perspex(?) screen that came with a rubber trim.
Problem is, the trim doesn’t seem to want to fit over the screen which appears too thick for the supplied trim
Tried silicone spray, warming the trim in hot water, neither worked.
Any suggestions or ideas to get it to fit?.
Thanks
 
1 - 3 of 3 Posts
Top