XSR 700 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
Can anyone tell me how to disconnect the plastic O2 sensor plug? I've had a look at it and it's not very obvious to me. I know these things are meant to be easy, usually a clip or something but I can't see it. I'm obviously missing something. Any help appreciated.
 

·
Registered
Joined
·
216 Posts
I had this same problem its a totaly crappy little plug.....so i got a small screwdriver and pushed it into the little square hole and wiggled the clip down. It worked but i dont think its the correct way........
 

·
Registered
Joined
·
13 Posts
Discussion Starter #3
Thanks Matt. You changing the stock exhaust too?

I was starting to butcher the connector trying to get it undone so in the end I went with the 'try to get the o2 sensor off while still plugged in method' which a few people have shown on youtube. It was a bad idea and I came pretty close to tearing the wires out of the o2 sensor. Wouldn't recommend it! But it did work for me this time. Don't think i'd get away with it twice.
 
1 - 3 of 3 Posts
Top