XSR 700 Forums banner

Air box removal and replace with cone fitlers x 2

8394 Views 3 Replies 3 Participants Last post by  John A
Anyone tried this mod to remove the stock air filter housing and replace with 2 x K&N cone filters. Looks really good! I bet it sounds good too. Love induction noise.

http://mt07tuning.tumblr.com/post/159379711693/air-box-removal

I reckon you'd need a remap after this as the engine would probably flow too well for the standard map, especially with a non stock exhaust.
  • Like
Reactions: 1
1 - 4 of 4 Posts
I have a mate that has done it on an MT-07 and not re-mapped his bike. It definitely looks good BUT you have to re-map the ECU. My bike leaves his for dead in every situation, out runs it down the straight and punches much harder out of corners, and my bike has only had the snorkel head removed from the airbox to allow for a little more air.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top